Here's the story:
Picked up a new Colt Defender two weeks ago. Went to the range, had some extraction problems; fairly random, but every 15 rounds, or so, the extractor would jump the rim and fail to extract. Get it home, check the extractor tension...is very weak. Well, no big deal, was going to have a local smith do a trigger job, so I figure Ill have him tune the extractor while it's there.
I have two brand new sets of Colt original equipment grip panels with Colt gold medallion for a Colt Government model. They have been sitting in storage for the 380 colt mustang. $25 shipped for each pair, buy both sets for $45 shipped.
So, pick the pistol up today (great trigger job BTW) and head straight to the range. Same crap. Head straight back to the smith, he adjusts the tension again. Get home, strip the pistol and check the tension with the extractor in the pistol (using the loaded round/shake the slide method). The extractor barely grips WWB cases, and Corbon and Speer brass falls right out. Scratch my head.
At this point I pull out two other 1911s that I know have perfect extractors (est. 8000 rounds through both with no extraction issues); both Kimbers. I remove the extractors from both pistols, and check the Colt 25 extractor in both. Tension is perfect in both Kimbers. So, I then try both of the Kimber extractors in the Colt...same problem, no tension on the case. At this point I'm getting what the problem is. Nevertheless, just to be sure, I grab a spare extractor to play around with. No matter how much bend I put in the Colt 1903, it still will not grip the case any harder; I had that extractor bent pretty much sideways and it made no ruger p 85 other than barely being able to push it in the channel.
Visually it appears the Colt extractor channel was cut too far to the side of the slide for the extractor to be tensioned, regardless of how much it is bent. Have not measured it, but based on the results from the three different p85 ruger, I'm guessing it is out of colt officer model
Agree? If not, what is your theory?
mspasfeh020
-
FINGER-ADJUSTABLE SCOPES:
After zeroing, you may use the hex wrench supplied with your scope to remove the windage and elevation drums and then reposition
them so that the zero ( 0 ) lines up with the indicator line on the spindle. Any further windage or elevation
adjustments can be made more precisely by calculating the amount of clicks from the zero point the windage and elevation
drums have been moved.
BAS Scopes rheostat, located at the top of the eyebell, controls the degrees of illumination. To prevent accidental discharge in shipping,
a plastic insulator has been placed within the battery compartment. To remove the plastic insulator, unscrew the battery cover
and remove the plastic from both sides of the battery. Replace the battery, being careful to insert the battery positive ( + ) side
up. Replace the battery cover firmly to assure that it is water tight. The illumination feature is activated by depressing and
releasing the small button located beside the battery compartment. The button should be depressed until a click is felt. The
first click will be the illuminator s least bright setting.
mwgsam80
